Circuito que alimenta outro por Indução Eletromagnética
Design a circuit about a lamp energized by AC current of 220V, 6A. Assuming that you meant 220V at 6A, and that you have a lamp with a power rating of 100W (which would correspond to a resistance of approximately 660 Ohms), here's a circuit you could use: Start by plugging a standard power cord into an electrical outlet. Make sure the cord has a plug that matches the type of outlet you're using. Cut the end of the power cord that doesn't have a plug, and strip the insulation off the wires to expose the conductive metal. Connect one wire from the power cord to one end of a switch. Connect the other end of the switch to one end of a fuse holder. Connect the other wire from the power cord to one end of the lamp. Connect the other end of the lamp to the other end of the fuse holder. Insert a fuse with a rating appropriate for the lamp's power rating into the fuse holder. Plug the cord into the outlet, and turn on the switch to energize the lamp. Note: This circuit is intend...